Chapter 6 Router Mode
NBG6815 User’s Guide
36
Figure 27 Expert Mode: Status > System Status: Router Mode
The following table describes the labels shown in the Status screen.
Table 14 Expert Mode: Status > System Status: Router Mode
LABEL DESCRIPTION
Device Information
Item This column shows the type of data the NBG6815 is recording.
Data This column shows the actual data recorded by the NBG6815.
Host Name This is the System Name you enter in the Maintenance > General screen. It is for
identification purposes.
Model Number This is the model name of your device.
Firmware Version This is the firmware version.
Sys OP Mode This is the device mode (Section 4.1.2 on page 26) to which the NBG6815 is set - Router
Mode.
WAN Information
MAC Address This shows the WAN Ethernet adapter MAC Address of your device.
IP Address This shows the WAN port’s IP address.
IP Subnet Mask This shows the WAN port’s subnet mask.
Default Gateway This shows the WAN port’s gateway IP address.
IPv6 Address This shows the IPv6 address of the NBG6815 on the WAN.
LAN Information
To Next Page
Loading...
