Chapter 8 Tutorials
NBG6815 User’s Guide
51
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 2.2 on page 14).
1 Make sure the WIFI switch (at the back panel of the NBG6815) is set to ON.
2 Open the Expert > Wireless > Wireless screen in the AP’s Web Configurator.
3 Confirm that the wireless LAN is enabled on the NBG6815.
4 Select to configure the wireless settings for the 2.4GHz wireless radio.
5 Enter SSID_Example3 as the SSID and select Channel-06 as the channel. Set security mode to
WPA2-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click
Apply.
6 Click Expert > Status to open the Status screen. Verify your wireless and wireless security
settings under Device Information and check if the WLAN connection is up under Interface
Status.
To Next Page
Loading...
