ZyXEL Communications NBG6815 - Page 94

Chapter 11 Wireless LAN
NBG6815 User’s Guide
94
Figure 60 Expert Mode > Wireless > Guest Wireless > Guest Wireless Setup: Edit
The following table describes the labels in this screen.
Table 30 Expert Mode > Wireless > Guest Wireless > Guest Wireless Setup: Edit
LABEL DESCRIPTION
Active Select this to activate the SSID profile.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Intra-BSS Traffic
Blocking
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled,
wireless clients can access the wired network and communicate with each other. When
Intra-BSS is disabled, wireless clients can still access the wired network but cannot
communicate with each other.
WMM QoS Check this to have the NBG6815 automatically give a service a priority level according to
the ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Enable
Bandwidth
Management for
Guest WLAN
Select this to turn on bandwidth management for the Guest Wi-Fi network.
Maximum
Bandwidth
Enter a number to specify maximum bandwidth the Guest Wi-Fi network can use.
Security Mode Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless
clients which want to associate to this network must have same wireless security settings
as this device. After you select to use a security, additional options appears in this screen.
See Section 11.3 on page 89 for detailed information on different security modes. Or you
can select No Security to allow any client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Apply Click Apply to save your changes back to the NBG6815.
Cancel Click Cancel to reload the previous configuration for this screen.