Chapter 13 IPSec
P-660HN-51 User’s Guide
149
Figure 76 IPSec Summary Fields
Local and remote IP addresses must be static.
Click Security Settings > IPSec to open the Settings screen. This is a menu of your IPSec tunnels.
Figure 77 Security Settings > IPSec > Settings
The following table describes the fields in this screen.
13.2.1 Add/Edit IPSec Setting
Click Add New Connection or a policy’s Edit icon in the IPSec > Settings screen to edit VPN policies.
Table 54 Security Settings > IPSec > Settings
LABEL DESCRIPTION
Add New
Connection
Click this to configure a new VPN policy.
# This is the index number of the entry.
Status This field displays whether the VPN policy is active or not. A yellow bulb signifies that this
VPN policy is active. A gray bulb signifies that this VPN policy is not active.
Connection
Name
This field displays the identification name for this VPN policy.
Remote
Gateway
This is the static WAN IP address or URL of the remote IPSec router.
Local Addresses This is the IP address of computer(s) on your local network behind your Zyxel Device.
Remote
Addresses
This is the IP address of computer(s) on the remote network behind the remote IPSec
router.
Modify Click the Edit icon to edit the VPN configuration.
Click the Delete icon to remove an existing VPN configuration.
Local Network
Local IP Address
My IP Address
Secure Gateway IP Address
Remote Network
Remote IP Address
Remote
IPSec Router
To Next Page
Loading...
