Chapter 15 Routing
P-660HN-51 User’s Guide
168
Figure 88 Advanced >Routing
The following table describes the labels in this screen.
15.2.1 Add/Edit Static Route
Use this screen to add or edit a static route. Click Add new Static Route Entry in the Routing screen or the
Edit icon next to the static route you want to edit. The screen shown next appears.
Figure 89 Routing: Add/Edit
Table 65 Advanced > Routing
LABEL DESCRIPTION
Add new Static
Route Entry
Click this to configure a new static route.
# This is the index number of the entry.
Status This field displays whether the static route is active or not. A yellow bulb signifies that
this route is active. A gray bulb signifies that this route is not active.
Name This is the name that describes or identifies this route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Modify Click the Edit icon to edit the static route on the Zyxel Device.
Click the Delete icon to remove a static route from the Zyxel Device. A window
displays asking you to confirm that you want to delete the route.
To Next Page
Loading...
