ZyXEL Communications P-660HN-51 - 17.7 The QoS Monitor Screen

Chapter 17 Quality of Service (QoS)
P-660HN-51 User’s Guide
186
17.6.1 Add/Edit a QoS Policer
Click Add new Officer in the Policer Setup screen or the Edit icon next to a policer to show the following
screen.
Figure 100 Policer Setup: Add/Edit
The following table describes the labels in this screen.
17.7 The QoS Monitor Screen
To view the Zyxel Device’s QoS packet statistics, click Advanced > QoS > Monitor. The screen appears as
shown.
Table 76 Policer Setup: Add/Edit
LABEL DESCRIPTION
Active Select the check box to activate this policer.
Name Enter the descriptive name of this policer.
Meter Type This shows the traffic metering algorithm used in this policer.
The Simple Token Bucket algorithm uses tokens in a bucket to control when traffic can
be transmitted. Each token represents one byte. The algorithm allows bursts of up to b
bytes which is also the bucket size.
Maximum Rate Specify the guaranteed rate at which packets are admitted to the network.
This is to specify how many bytes of tokens are added to a bucket every second.
Burst Size Specify the guaranteed amount of bytes that are admitted at the committed rate.
This is the maximum size of the (first) token bucket in a traffic metering algorithm.
Available Class
Selected Class
Select a QoS classifier to apply this QoS policer to traffic that matches the QoS classifier.
Highlight a QoS classifier in the Available Class box and use the > button to move it to
the Selected Class box.
To remove a QoS classifier from the Selected Class box, select it and use the < button.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.