ZyXEL Communications P-660HN-51 - Restore Configuration; Reset to Factory Defaults

Chapter 28 Configuration
P-660HN-51 User’s Guide
219
Restore Configuration
Restore Configuration allows you to upload a new or previously saved configuration file from your
computer to your Zyxel Device.
Do not turn off the Zyxel Device while configuration file upload is in
progress.
After the Zyxel Device configuration has been restored successfully, the login screen appears. Login
again to restart the Zyxel Device.
The Zyxel Device automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 121 Network Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your computer
to be in the same subnet as that of the default device IP address (192.168.1.1). See Appendix A on page
235 for details on how to set up your computer’s IP address.
If the upload was not successful, the following screen will appear. Click OK to go back to the
Configuration screen.
Figure 122 Configuration Upload Error
Reset to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the Zyxel Device to
its factory defaults. The following warning screen appears.
Table 97 Restore Configuration
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Browse... Click this to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Upload Click this to begin the upload process.