Chapter 17 Quality of Service (QoS)
P-660HN-51 User’s Guide
178
The following table describes the labels in this screen.
17.4 The Queue Setup Screen
Click Advanced > QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Figure 95 Advanced > QoS > Queue Setup
The following table describes the labels in this screen.
Table 70 Advanced > QoS > General
LABEL DESCRIPTION
QoS Select the Enable check box to turn on QoS to improve your network performance.
WAN Managed
Upstream
Bandwidth
Enter the amount of upstream bandwidth for the WAN interface that you want to
allocate using QoS.
The recommendation is to set this speed to match the interface’s actual transmission
speed. For example, set the WAN interface speed to 100000 kbps if your Internet
connection has an upstream transmission speed of 100 Mbps.
You can set this number higher than the interface’s actual transmission speed. The
Zyxel Device uses up to 95% of the DSL port’s actual upstream transmission speed
even if you set this number higher than the DSL port’s actual transmission speed.
You can also set this number lower than the interface’s actual transmission speed.
This will cause the Zyxel Device to not use some of the interface’s available
bandwidth.
If you leave this field blank, the Zyxel Device automatically sets this number to be 95%
of the DSL port’s actual upstream transmission speed.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 71 Advanced > QoS > Queue Setup
LABEL DESCRIPTION
Add new
Queue
Click this button to create a new queue entry.
# This is the index number of the entry.
To Next Page
Loading...
