ZyXEL Communications P-660HN-51 - Add;Edit Policy Forwarding

Chapter 21 Policy Forwarding
P-660HN-51 User’s Guide
200
21.2.1 Add/Edit Policy Forwarding
Click Add new Policy Forward Rule in the Policy Forwarding screen or click the Edit icon next to a policy.
Use this screen to configure the required information for a policy route.
Figure 107 Policy Forwarding: Add/Edit
The following table describes the labels in this screen.
WAN This is the WAN interface through which the traffic is routed.
Modify Click the Edit icon to edit this policy.
Click the Delete icon to delete an existing policy.
Table 84 Advanced > Policy Forwarding (continued)
LABEL DESCRIPTION
Table 85 Policy Forwarding: Add/Edit
LABEL DESCRIPTION
Policy Name Enter a descriptive name of up to 8 printable English keyboard characters, not
including spaces.
Source IP
Address
Enter the source IP address.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol Select the transport layer protocol (TCP or UDP).
Source Port Enter the source port number.
Source Mac Enter the source MAC address.
WAN Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.