ZyXEL Communications P-660HN-51 - 17.6 The QoS Policer Setup Screen

Chapter 17 Quality of Service (QoS)
P-660HN-51 User’s Guide
185
17.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming traffic.
Click Advanced > QoS > Policer Setup. The screen appears as shown.
Figure 99 Advanced > QoS > Policer Setup
The following table describes the labels in this screen.
VLAN ID If you select Remark, enter a VLAN ID number with which the Zyxel Device
replaces the VLAN ID of the frames.
If you select Remove, the Zyxel Device deletes the VLAN ID of the frames before
forwarding them out.
If you select Add, the Zyxel Device treat all matched traffic untagged and add a
second VLAN ID.
If you select Unchange, the Zyxel Device keep the VLAN ID in the packets.
To Queue Index Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 74 Class Setup: Add/Edit (continued)
LABEL DESCRIPTION
Table 75 Advanced > QoS > Policer Setup
LABEL DESCRIPTION
Add new Policer Click this to create a new entry.
# This is the index number of the entry.
Status This field displays whether the policer is active or not. A yellow bulb signifies that this
policer is active. A gray bulb signifies that this policer is not active.
Name This field displays the descriptive name of this policer.
Regulated Classes This field displays the name of a QoS classifier
Meter Type This field displays the type of QoS metering algorithm used in this policer.
Maximum Rate This field displays the maximum rate configured for the metering algorithm in the
policer.
Burst Size This field displays the burst size configured for the metering algorithm in the policer.
Modify Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules
move up by one when you take this action.