ZyXEL Communications P-660HN-51 - Page 194

Chapter 18 TR-069 Client
P-660HN-51 User’s Guide
194
The following table describes the fields in this screen.
Table 80 Advanced > TR-069 Clients
LABEL DESCRIPTION
Inform Select Enable for the Zyxel Device to send periodic inform via TR-069 on the WAN.
Otherwise, select Disable.
Inform Interval Enter the time interval (in seconds) at which the Zyxel Device sends information to
the auto-configuration server.
ACS URL Enter the URL or IP address of the auto-configuration server.
ACS User Name Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-configuration server.
WAN Interface used
by TR-069 client
Select a WAN interface through which the TR-069 traffic passes.
If you select Any_WAN, you should also select the pre-configured WAN
connection(s).
Display SOAP
messages on serial
console
Select Enable to show the SOAP messages on the console.
Connection
Request
Authentication
Select this option to enable authentication when there is a connection request
from the ACS.
Connection
Request User Name
Enter the connection request user name.
When the ACS makes a connection request to the Zyxel Device, this user name is
used to authenticate the ACS.
Connection
Request Password
Enter the connection request password.
When the ACS makes a connection request to the Zyxel Device, this password is
used to authenticate the ACS.
Connection
Request URL
This shows the connection request URL.
The ACS can use this URL to make a connection request to the Zyxel Device.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.