Chapter 4 Tutorials
P-660HN-51 User’s Guide
34
4 Push and hold the WPS button located on the Zyxel Device’s front panel for 5 to 10 seconds. The WLAN/
WPS LED starts blinking orange. Alternatively, you can log into Zyxel Device’s web configurator and go
to the Network Settings > Wireless > WPS screen. Click the Connect button.
Note: Your Zyxel Device has a WLAN/WPS button located on its front panel as well as a
Connect button in its configuration utility. Both buttons have exactly the same function:
you can use one or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
The Zyxel Device sends the proper configuration settings to the wireless client. This may take up to two
minutes. The wireless client is then able to communicate with the Zyxel Device securely.
The following figure shows you an example of how to set up a wireless network and its security by
pressing a button on both Zyxel Device and wireless client.
To Next Page
Loading...
