Chapter 5 Broadband
P-660HN-51 User’s Guide
52
PPP Username Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both
components exactly as given.
PPP Password Enter the password associated with the user name above.
PPP Auto Connect Select this option if you do not want the connection to time out.
IDLE Timeout This value specifies the time in minutes that elapses before the router automatically
disconnects from the PPPoE server.
This field is not configurable if you select PPP Auto Connect.
PPPoE Service
Name
Enter the name of your PPPoE service here.
PPPoE Passthrough This field is available when you select PPPoE encapsulation.
In addition to the Zyxel Device’s built-in PPPoE client, you can enable PPPoE pass
through to allow up to ten hosts on the LAN to use PPPoE client software on their
computers to connect to the ISP via the Zyxel Device. Each host can have a
separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
IP Address This is available only when you select IPoE or IPoA in the Mode field.
Obtain an IP
Address
Automatically
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not
fixed; the ISP assigns you a different one each time you connect to the Internet.
Select this if you have a dynamic IP address.
Static IP Address Select this option If the ISP assigned a fixed IP address.
IP Address Enter the static IP address provided by your ISP.
IP Subnet Mask Enter the subnet mask provided by your ISP.
Gateway IP
Address
Enter the gateway IP address provided by your ISP.
Routing Feature
NAT Enable Select this option to activate NAT on this connection.
IGMP Proxy Enable Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to
establish membership in a Multicast group - it is not used to carry user data.
Select this option to have the Zyxel Device act as an IGMP proxy on this connection.
This allows the Zyxel Device to get subscribing information and maintain a joined
member list for each multicast group. It can reduce multicast traffic significantly.
Apply as Default
Gateway
Select this option to have the Zyxel Device use the WAN interface of this connection
as the system default gateway.
DNS Server This is available only when you select Apply as Default Gateway in the Routing
Feature field.
DNS Select Dynamic if you want the Zyxel Device use the DNS server addresses assigned
by your ISP.
Select Static if you want the Zyxel Device use the DNS server addresses you
configure manually.
DNS Server 1 Enter the first DNS server address assigned by the ISP.
DNS Server 2 Enter the second DNS server address assigned by the ISP.
Apply Click Apply to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving.
Table 6 Broadband: Add/Edit: Routing Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
