Chapter 6 Wireless
P-660HN-51 User’s Guide
74
Figure 26 Network Settings > Wireless > WDS
The following table describes the labels in this screen.
Table 18 Network Settings > Wireless > WDS
LABEL DESCRIPTION
Wireless Bridge Setup
AP Mode Select the operating mode for your Zyxel Device.
• Access Point - The Zyxel Device functions as a bridge and access point
simultaneously.
• Wireless Bridge - The Zyxel Device acts as a wireless network bridge and
establishes wireless links with other APs. In this mode, clients cannot connect to
the Zyxel Device wirelessly.
Bridge Restrict This field is available only when you set operating mode to Access Point.
Select Enabled to turn on WDS and enter the peer device’s MAC address manually in
the table below. Select Disable to turn off WDS.
Remote Bridge
MAC Address
You can enter the MAC address of the peer device by clicking the Edit icon under
Modify.
# This is the index number of the entry.
MAC Address This shows the MAC address of the peer device.
You can connect to up to 4 peer devices.
Modify Click the Edit icon and type the MAC address of the peer device in a valid MAC
address format (six hexadecimal character pairs, for example 12:34:56:78:9a:bc).
Click the Delete icon to remove this entry.
Scan Click the Scan icon to search and display the available APs within range.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
