ZyXEL Communications P-660HN-51 - Page 94

Chapter 7 Home Networking
P-660HN-51 User’s Guide
94
Figure 37 Network Settings > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 23 Network Settings > Home Networking > LAN Setup
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your Zyxel Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Zyxel Device automatically computes the
subnet mask based on the IP Address you enter, so do not change this field unless
you are instructed to do so.
DHCP Server State
DHCP Select Enable to have the Zyxel Device act as a DHCP server or DHCP relay agent.
Select Disable to stop the DHCP server on the Zyxel Device.
Select DHCP Relay to have the Zyxel Device forward DHCP request to the DHCP
server.
DHCP Relay Server
Address
This field is only available when you select DHCP Relay in the DHCP field.
IP Address Enter the IP address of the actual remote DHCP server in this field.
IP Addressing Values This field is only available when you select Enable in the DHCP field.
Beginning IP
Address
This field specifies the first of the contiguous addresses in the IP address pool.
Ending IP Address This field specifies the last of the contiguous addresses in the IP address pool.