ZyXEL Communications P-660R-T1 - Using Zero-Configuration

P-660 series Support Notes
Destination
IP Address
Enter the IP address of destination that meats this class.
Destination
Subnet Mask
Enter the destination subnet mask.
Destina
Por
traffic.
tion
Enter the destinatio
t
n port number of the
Source IP
eats this class. Note that for traffic from
'LAN to WAN', since BWM is before NAT, you should use the IP address
processing.
Enter the IP address of source that m
Address
before NAT
Source
Subnet Mask
Enter the destination subnet mask.
Source Port
Enter the source port number of the traffic.
Protocol ID
Enter the protocol number for the traffic. 1 for ICMP, 6 for TCP or 17 for UDP
After configuration BWM, you can check current bandwidth of the configured traffic
in ADVANCED->BWM MGMT->Monitor. The values in the column of Current
usage (kbps) would display the actually number.
15. Using Zero-Configuration
• Zero-Configuration and VC auto-hunting
Zero-Configure feature can help customer to reduce the burden of setting efforts.
Whenever system ADSL links up system will send out some probing patterns, system
will analyze the packets returned from ISP, and decide which services the ISP may
provide. Because ADSL is based on a ATM network, so system have to
pre-configured a VPI/VCI hunting pool before Auto-Configure function begins to
work.
The Zero-Configuration feature can hunt the encapsulation and VPI/VCI value, and
system will automatically configure itself if the hunting result is successfully. This
feature has two constraints:
1. It supports the ISP provides one kind of service (PPPoE/PPPoA..etc.) only,
otherwise the hunting will get confusing and failed.
ic WAN IP address. If the router is set a
static WAN IP address. VC auto-hunting function will be disabled.
o contain the VPI, VCI, and which kinds of hunting
patterns you wish to send. Whenever system send out all the probing patterns with
ill decide which kinds of ADSL services of the line will be.
2. VC auto-hunting only supports dynam
The entry of hunting pool must als
specific VPI/VCI, system will wait for 5~10 seconds and get the response from ISP,
the response patterns w
107
All contents copyright © 2005 ZyXEL Communications Corporation.