ZyXEL Communications P-660R-T1 - WAN Related Commands

P-660 series Support Notes
load <set id> load nat server
information from ROM
save save nat server
information to ROM
clear <set id> clear nat server
information
edit active <yes|no> set nat server edit active
flag
edit svrport <start port> [end
port]
set nat server server port
edit intport <start port> [end
port]
set nat server forward port
edit remotehost <start ip> [end
ip]
set nat server remote host
ip
edit leasetime [time] set nat server lease time
edit rulename [name] set nat server rule name
edit forwardip [ip] set nat server server ip
edit protocol [protocol id] set nat server protocol
service
irc [on|off] turn on/off irc flag
resetport reset all nat server table
entries
incikeport [on|off] turn on/off increase ike
port flag
5. WAN Related Commands
Command Description
wan adsl bert
ADSL ber
chandata ADSL channel data, line rate
close Close ADSL line
coding ADSL standard current
ctrleint ADSL CTRLE response
command
defbitmap ADSL defect bitmap status
dyinggasp Send ADSL dyinggasp
fwav Test the ADSL F/W available
ping
fwdl Download modem code, but
must reset first
linedata
near Show ADSL near end noise
margin
180
All contents copyright © 2005 ZyXEL Communications Corporation.