P-660 series Support Notes
60
t in
e-configured, read only, Many-to-One mapping set,
sufficient for most purposes and helpful to people already familiar with SUA in
enus
Applying NAT in the SMT Menus
You apply NAT via men d 11.3 as
apply NAT for Internet access in menu 4 enu
4-Internet Access Setup.
servers had to be of different types. The P-660 supports NAT sets on a remote node
basis. They are reusable, but only one set is allowed for each remote node. The P-6
supports 8 sets since there are 8 remote node. The default SUA (Read Only) Se
menu 15.1 is a convenient, pr
previous ZyNOS versions.
SMT M
us 4 an displayed next. The next figure how you
. Enter 4 from the Main Menu to go to M
Menu 4 - Internet Access Setup
me= ISP's Na CHT
Encapsulation= PPPoE
Multiplexing= LLC-based
VPI #= 0
VCI #= 33
ATM QoS T R ype= CB
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= cso@hinet.net
My Password= ********
Idle Timeout (sec)= 0
IP Address Assignment= Static
IP Address= 200.1.2.1
Network Address Translation= Full Feature
Address Mapping Set= 1
Press ENTER to Confirm or ESC to Cancel:
The following figure shows how you apply NAT to the remote node in menu 11.3.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Dynamic
44
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
