P-660 series Support Notes
dygasprecover
dygasprecover level [value] By default is 100, after
receiving 100 dying gasp
system will reboot
dygasprecover active [on|off| Turn on/off this mechanism
rsploss [1|0] Turn on means to response
signal loss of CTRLE
immediately, default is off
atm test [fix|rand|period|oam|loopback] Generate ATM traffic
hwsar disp
Display hwsar packets
incoming/outgoing
information
clear
Clear hwsar packets
information
6. PPP Related Command
Command Description
ppp
bod
remote <iface> show remote bod
information
reset
reset bod
setremote <iface> set remote bod
status <wan_iface> show wan port bod
status
clear <wan_iface> clear wan port bod data
on
set bod flag on
off
set bod flag off
node <node> <dir> config the statistic
method for remote node
bod traffic data
debug [on|off] show bod debug flag
cnt
disp show bod state
clear clear bod state
ccp
[on|off] set/display dial-in ccp
switch
lcp
acfc [on|off] set address/control field
compression flag
pfc [on|off] set protocol field
compression flag
183
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
