P-660 series Support Notes
this value, and rate is
worse?than before, then
system will do ?1 shutdown
RA3? default is 8db
persisttime [time]
when the adaptive condition is
matched system will continue to
monitor the time
period ?ersisttime?before
doing ?1 shutdown RA3? default
is 30 seconds
timeinterval [mins] when ?1 shutdown RA3?is
done twice, and still can?
reach the max rate which
system recorded, it will delay
a time period that the period
base time
is?imeinterval?before starting
again. The time-based default
is 2 hrs
defectcheck [on|off] Turn on/off detect table
checking, default is on
txgain [value] Set the CTRLE register
(0xc3), the value is from 0xfa
to 0x06
targetnoise [value] Set the CTRLE register
(0xc4), the value is from 0xfa
to 0x06
maxtonelimit [value] Set the CTRLE register
(0xc5), the value is from 0xfa
to 0x06
rxgain [value] Set the CTRLE register
(0xc6), the value is from 0xfa
to 0x06
txoutputpwr [value] Set the CTRLE register
(0xc7), the value is from 0xfa
to 0x06
rxoutputpwr [value] Set the CTRLE register
(0xc8), the value is from 0xfa
to 0x06
maxoutputpwr [value] Set the CTRLE register
(0xc9), the value is from 0xfa
to 0x06
errorsecond
sendes Send current error second
information immediately
182
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
