P-660 series Support Notes
netbios
disp display netbios filter
status
config <0:LAN to WAN, 1:WAN to LAN,
2:LAN to DMZ, 3:IPSec passthrough,
4:Trigger Dial> <on|off>
config netbios filter
ddns
debug <level> enable/disable ddns
service
display <iface name> display ddns
information
restart <iface name> restart ddns
logout <iface name> logout ddns
cpu
display
display CPU
utilization
2. Exit Related Commands
Command Description
exit
exit smt menu
3. Ethernet Related Commands
<ch-name> : enet0, mpoa00
Command Description
ether
config
display LAN configuration
information
driver
cnt
disp <name> display ether driver counters
clear <name> clear ether driver counters
iface <ch_name> <num> send driver iface
ioctl <ch_name> Useless in this stage.
mac <ch_name> <mac_addr> Set LAN Mac address
reg <ch_name> display LAN hardware related
registers
rxmod <ch_name> <mode>
set LAN receive mode.
173
All contents copyright © 2005 ZyXEL Communications Corporation.