P-660 series Support Notes
If you use WEB configuration, the MAC Address Filter configuration are as shown
below.
1. Using a web browser, login AP by giving the LAN IP address of AP in URL
the left.
3. Click MAC Filter tab on the top and select Yes in the Active field to enable
m hosts in the list.
5. Enter the MAC Addresses which you may want to apply the filter to allow or
ociations from.
6. Click Apply to make your setting work.
field. Default LAN IP is 192.168.1.1, default password to login web
configurator is 1234.
2. Click Advanced, and click Wireless tab on
MAC Filter.
4. Select the Filter Action to allow or deny association fro
block ass
4. Setup WEP (Wired Equivalent Privacy)
• Introduction
• Setting up the Access Point
• Setting up the Station
123
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
