ZyXEL Communications P-660R-T1 - Page 123

P-660 series Support Notes
fig /all" after DOS prompt to get the MAC (physical)
you use SMT management, the MAC Address Filter configurations are as shown
wireless cards in the filter set to allow or deny
m these cards.
please enter a command "ipcon
address of your wireless client.
If
below.
Enter the MAC Addresses of
association fro
Menu 3.5.1 - WLAN MAC Address Filter
Active= Yes
Filter Action= Allowed Association
------------------------------------------------------------------------------
1= 11:11:11:11:11:11 13= 00:00:00:00:00:00 25= 00:00:00:00:00:00
2= 00:00:00:00:00:00 14= 00:00:00:00:00:00 26= 00:00:00:00:00:00
3= 00:00:00:00:00:00 15= 00:00:00:00:00:00 27= 00:00:00:00:00:00
4= 00:00:00:00:00:00 16= 00:00:00:00:00:00 28= 00:00:00:00:00:00
5= 00:00:00:00:00:00 17= 00:00:00:00:00:00 29= 00:00:00:00:00:00
6 0 00:00:00 30= 00:00:00:00:00:00 = 0 :00:00:00:00:00 18= 00:00:00:
7 0 19= 00:00:00:00:00:00 31= 00:00:00:00:00:00 = 0 :00:00:00:00:00
8 0 = 00:00:00:00:00:00 32= 00:00:00:00:00:00 = 0 :00:00:00:00:00 20
9= 00:00:00:00:00:00 21= 00:00:00:00:00:00
10= 00:00:00:00:00:00 22= 00:00:00:00:00:00
11= 00:00:00:00:00:00 23= 00:00:00:00:00:00
12= 00:00:00:00:00:00 24= 00:00:00:00:00:00
------------------------------------------------------------------------------
ENTER here to CONFIRM or ESC to CANCEL:
Key Settings:
Option Descriptions
Filter Action
is selected in this field, hosts with MAC addresses configured in this list w
Allow or block association from MAC addresses contained in this list. If Allow Association
ill be allowed to
associate with AP. If Deny Association is selected in this field, hosts with MAC addresses
configured in this list will be blocked.
MAC Address
This field specifies those MAC Addresses that you want to add in the list.
122
All contents copyright © 2005 ZyXEL Communications Corporation.