ZyXEL Communications P-660R-T1 - Using Syslog; Setup

P-660 series Support Notes
Get Community= public
Set Community= public
Trusted Host= 192.168.1.33
Trap:
Community= public
Destination= 192.168.1.33
Press ENTER to Confirm or ESC to Cancel:
Key Settings:
Option Descriptions
Get
Community
Enter the correct Get Community. This Get Community must match the 'Get-'
and 'GetNext' community requested from the NMS. The default is 'public'.
Set
Community
Enter the correct Set Community. This Set Community must ma
'Set-community requested from the NMS. The default is 'public'
tch the
.
Trusted Host
Enter the IP address of the NMS. The P-660 will only respond to
messages coming from this IP address. If 0.0.0.0 is entered, the
respond to all NMS managers.
SNMP
P-660 will
Trap
Community
Enter the community name in each sent trap to the NMS. This Tra
must match what the NMS is expecting. The default is 'public'.
p Community
Trap
Destination
Enter the IP address of the NMS that you wish to send the traps
entered, the P-660 will not send trap any NMS manager.
to. If 0.0.0.0 is
UNIX Setup
9. Using syslog
• P-660 Setup
•
• ZyXEL Syslog Message Format
P-660 Setup
Menu 24.3.2 - System Maintenance - UNIX S nd Accounting yslog a
UNIX Syslog:
Active= Yes
Syslog IP Address= 192.168.1.33
88
All contents copyright © 2005 ZyXEL Communications Corporation.