P-660 series Support Notes
bit4:Enet/VC (16),
bit5 :Enet/LLC (32)
For examples:
If you need service PPPoE/LLC
and Enet/LLC then the service
bits will be 2+32 = 34 (decimal)
= 22 (hex), you must input 22
Need to perform save after this
command
Remove <removeNodeId>
<vpi> <vci>
Input remote node ID and vpi,
vci value to remove the specific
entry. System will save
automatically.
Active <yes|no> Enable VC auto hunting featurer
display Display the hunt pool
Clear Clear the configure buffer
Save Save current setting into ROM
file
timer The waiting time before
checking the hunting table result
Send VC hunt pattern again Send
C auto result Check the result of V
hunting
1. After configure the auto-haunting preconfigured table. You just need a PC
account, if your ISP provide PPPoE
or PPPoA service.
3. After key-in the correct info, it will than test the connection. If it is
successful it will than close the browser and you can open a new browser to
surf the Internet. If the connection test fail, it will go back to the page ask for
user name and password.
The user name or password are incorrect. You need to keyin again to retry.
• Using Zero configuration.
connected to the device LAN Ethernet port with the DSL sync up.
2. Open your web browser to access a Web site. It should prompt and request
for your username password of your ISP
110
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
