P-660 series Support Notes
d call filter sets.
w for the packet from WAN to LAN is:
• WAN device output an
The sequence of the logic flo
WAN device input filter sets.
If SUA is enabled, SUA converts the destination IP address from 203.205.115.6 to
92.168.1.33 and port number from 4034 to 1023.
WAN protocol input filter sets.
LAN device and protocol output filter sets.
Gen (and IPX) filter rules are in different filter sets. The SMT will
detect and prevent the mixing of different category rules within any filter set in Menu
nd device
filter rules cannot be active together' if you try to activate a TCP/IP (or IPX) filter
Generic filter rules. You will
u try to activate a Generic filter rule in a filter set that has
eric and TCP/IP
21. In the following example, you will receive an error message 'Protocol a
rule in a filter set that has already had one or more active
receive the same error if yo
already had one or more active TCP/IP (or IPX) filter rules.
Menu 21.1.1:
62
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
