P-660 series Support Notes
2. One rule for blocking all packets from this client
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 0 IP Source Route= No
Destination: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #=
Port # Comp= None
Source: IP Addr= 192.168.1.5
IP Mask= 255.255.255.255
Port #=
Port # Comp= None
TCP Estab= N/A
More= No Log= None
Action Matched= Drop
Action Not Matched= Forward
irm or ESC to Cancel: Press ENTER to Conf
Key Se
Source IP addr................Enter the client IP in this field
IP Mask..........................Here the IP mask is used to mask the bits of the IP address
given in tation it is 255.255.255.255.
Action Matched................Set to 'Drop' to drop all the packets from this client
Action Not Matched.........Set to '
3. Appl umber '1' to the 'Output Protocol Filter Set' field in the
remote
A filter for blocking a specific MAC address
This co
MAC a
Before you Begin
ttings:
the 'Source IP Addr=' field, for one works
Forward' to allow the packets from other clients
y the filter set n
node setup.
nfiguration example shows you how to use a Generic Filter to block a specific
ddress of the LAN.
69
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
