P-660 series Support Notes
More= No Log= None
Action Matched= Drop
Action Not Matched= Forward
Key Settings:
• Generic Filter Ruls
Set the 'Filter Type' to 'Generic Filter Rule'
• Active
Set to '6' since the source MAC address starts at 7th octets we need to skip the
ress.
octets.
cally qualify (logical AND) the data
ctets the Mask for it should be 12 hexadecimal
t to 'ffffffffffff' to mask the incoming
4c ea 63].
that the P-660 should use to
t. If the result from the masked packet matches
atched.
acket matches the 'Value'. In this
case, we will drop it.
• Action Not Matched=
. In
this case, we will forward it. If you want to configure more rules please select
'Check Next Rule' to start configuring the next new rule. However, please note
not others. Because
the Generic and TCPIP (IPX) filter rules must be in different filter sets.
Turn 'Active' to 'Yes'
• Offset (in bytes)
first octets of the destination MAC add
Length (in bytes)
Set to '6' since MAC address has 6
Mask (in hexadecimal)
Specify the value that the P-660 will logi
in the packet.
Since the Length is set to 6 o
numbers. In this case, we intent to se
source MAC address, [00 80 c8
• Value (in hexadecimal)
Specify the MAC address [00 80 c8 4c ea 63]
compare with the masked packe
the 'Value', then the packet is considered m
• Action Matched=
Enter the action you want if the masked p
Enter the action you want if the masked packet does not match the 'Value'
that the 'Filter Type' must be also 'Generic Filter Rule' but
72
All contents copyright © 2005 ZyXEL Communications Corporation.
To Next Page
Loading...
