Chapter 14 Redirect Service
ZyWALL USG Series User’s Guide
451
14.2.1 The Redirect Service Edit Screen
Click Network > Redirect Service to open the Redirect Service screen. Then click the Add or Edit icon to
open the Redirect Service Edit screen where you can configure the rule.
Figure 313 Network > Redirect Service > Edit
The following table describes the labels in this screen.
Interface This is the interface on which the request must be received.
Source Address This is the name of the source IP address object from which the traffic should be sent. If any
displays, the rule is effective for every source.
Server This is the IP address of the HTTP proxy server or the SMTP server to which the matched traffic
is forwarded.
Port This is the service port number used by the HTTP proxy server or SMTP server.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 156 Configuration > Network > Redirect Service (continued)
LABEL DESCRIPTION
Table 157 Network > Redirect Service > Edit
LABEL DESCRIPTION
Enable Use this option to turn the Redirect Service rule on or off.
Service Select the service to be redirected: HTTP Redirect or SMTP redirect.
Name Enter a name to identify this rule. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value
is case-sensitive.
Criteria
To Next Page
Loading...
