ZyXEL Communications ZyWALL 310 - Add Application Rule

Chapter 43 Object
ZyWALL USG Series User’s Guide
837
43.6.1 Add Application Rule
Click Add in Configuration > Object > Application > Application to create a new application rule. In the
first screen you type a name to identify this application object and write an optional brief description of
it.
You then click Add again to choose the signatures that should go into this object.
Figure 577 Configuration > Object > Application > Application > Add Application Rule
The following table describes the labels in this screen.
Released
Date
This field shows the date (YYYY-MM-DD) and time the current signature version was released.
Update
Signatures
If your signature set is not the most recent, click this to go to Configuration > Licensing >
Signature Update > IDP / AppPatrol to update your signatures.
Table 317 Configuration > Object > Application > Application (continued)
LABEL DESCRIPTION
Table 318 Configuration > Object > Application > Application > Add Application Rule
LABEL DESCRIPTION
Name Type a name to identify this application rule. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Description You may type some extra information on the application object here.
Add Click this to create a new application rule.
Remove Click this to remove the selected application rule.
# This field is a sequential value associated with this application rule.
Category This field shows the category to which the signature belongs in this application rule.
Application This displays the name of the application signature used in this application rule.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.