Chapter 43 Object
ZyWALL USG Series User’s Guide
852
Figure 589 Configuration > Object > Service > Service
The following table describes the labels in this screen.
43.8.2.1 The Service Add/Edit Screen
The Service Add/Edit screen allows you to create a new service or edit an existing one. To access this
screen, go to the Service screen (see Section 43.8.2 on page 851), and click either the Add icon or an
Edit icon.
Figure 590 Configuration > Object > Service > Service > Edit
The following table describes the labels in this screen.
Table 330 Configuration > Object > Service > Service
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific service.
Name This field displays the name of each service.
Content This field displays a description of each service.
Reference This displays the number of times an object reference is used in a profile.
Table 331 Configuration > Object > Service > Service > Edit
LABEL DESCRIPTION
Name Type the name used to refer to the service. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
IP Protocol Select the protocol the service uses. Choices are: TCP, UDP, ICMP, ICMPv6, and User Defined.
To Next Page
Loading...
