Chapter 43 Object
ZyWALL USG Series User’s Guide
854
43.8.3.1 The Service Group Add/Edit Screen
The Service Group Add/Edit screen allows you to create a new service group or edit an existing one. To
access this screen, go to the Service Group screen (see Section 43.8.3 on page 853), and click either the
Add icon or an Edit icon.
Figure 592 Configuration > Object > Service > Service Group > Edit
The following table describes the labels in this screen.
Family This field displays the Server Group supported type, which is according to your configurations in
the Service Group Add/Edit screen.
There are 3 types of families:
• : Supports IPv4 only
• : Supports IPv6 only
• : Supports both IPv4 and IPv6
Name This field displays the name of each service group.
By default, the Zyxel Device uses services starting with “Default_Allow_” in the security policies
to allow certain services to connect to the Zyxel Device.
Description This field displays the description of each service group, if any.
Reference This displays the number of times an object reference is used in a profile.
Table 332 Configuration > Object > Service > Service Group (continued)
LABEL DESCRIPTION
Table 333 Configuration > Object > Service > Service Group > Edit
LABEL DESCRIPTION
Name Enter the name of the service group. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Description Enter a description of the service group, if any. You can use up to 60 printable ASCII characters.
To Next Page
Loading...
