Chapter 44 System
ZyWALL USG Series User’s Guide
955
Figure 680 Configuration > System > Notification > Mail Server
The following table describes the labels in this screen.
Table 385 Configuration > System > Notification > Mail Server
LABEL DESCRIPTION
Mail Server Type the name or IP address of the outgoing SMTP server.
Mail Subject Go to Configuration > Log & Report > Email Daily Report to type a subject line for outgoing e-
mail from the Zyxel Device.
Append
system name
Select Append system name to add the Zyxel Device’s system name to the subject.
Append date
time
Select Append date time to add the Zyxel Device’s system date and time to the subject.
Mail Server Port Enter the same port number here as is on the mail server for mail traffic.
TLS Security Select this option if the mail server uses Transport Layer Security (TLS) for encrypted
communications between the mail server and the Zyxel Device.
STARTTLS Select this option if the mail server uses SSL or TLS for encrypted communications between the
mail server and the Zyxel Device.
Authenticate
Server
Select this if the Zyxel Device authenticates the mail server in the TLS handshake.
Mail From Type the e-mail address from which the outgoing e-mail is delivered. This address is used in
replies.
SMTP
Authentication
Select this check box if it is necessary to provide a user name and password to the SMTP server.
User Name This box is effective when you select the SMTP Authentication check box. Type the user name
to provide to the SMTP server when the log is e-mailed.
Password This box is effective when you select the SMTP Authentication check box. Type a password of
up to 63 characters to provide to the SMTP server when the log is e-mailed.
Retype to
Confirm
Type the password again to make sure that you have entered is correctly.
Time for sending
report
Select the time of day (hours and minutes) when the log is e-mailed. Use 24-hour notation.
To Next Page
Loading...
