2N IP Verso - Electric Installation

Installation manual 2N® IP Verso
168 / 241
1.
2.
1.
2.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
2.3 Electric Installation
This subsection describes how to install the modules, how to connect the2N
®
IP Versomain
unit to the power supply and LAN and how to connect other elements.
Mounting Preparation
Unscrew the second module cover on the main unit base.
Use a flat screwdriver to take out the module cover.
Version A – 2-Module Base
Place the base on the flush mounting box / predrilled holes with dowels and pull the
cables through the bottom holes. Pull the Ethernet cable including the connector through
the bottom hole to the left if necessary.
Insert the metal fitting elements up and down and screw the base plate tight. You can
level the base slightly if you are mounting just one base.
Version B – 3-Module Base
Unscrew the cover of the additional base.
Use a flat screwdriver to take out the cover.
Slide the additional base to the main unit base and secure its position with the small side
wedges and screws.
Remove the microphone from the main unit base and loosen the microphone cable.
Lead the microphone to the third module base as shown in the figure.
Place the joined bases on the flush mounting box / predrilled holes with dowelsand pull
the cables through the bottom holes. Feedthe Ethernet cable without the connector from
the additional base to the main unit base if necessary.
Version C – Additional Columns
Unscrew the cover of the additional bases and take it out with a flat screwdriver.
Insert the bases into each other as projected and secure their position with the small side
wedges and screws.
Place the cover on the flush mounting box / predrilled holes with dowels and pull the
cables if any through the bottom holes.
Pull the bus using the cable bushingavailable in the flush mounting box.
•
Caution
The device must be part of the electrical system of the building.
