2N IP Verso - Induction Loop

Installation manual 2N® IP Verso
195 / 241
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Technical specification:
Resolution: 320 px x 214 px H x V
Resolution slideshow: 214 px x 214 px
Contrast ratio: 400
Brightness: 350 cd/m2
Weight: 280 g
Working temperature: −20 °C – 60 °C
Resistance level: IK07
Induction Loop
TheInduction loop (Part No. 9155041)is one of the2N
®
IP Versointercom elements and is
used to transmit an audio signal directly into a hearing aid via a magnetic field.
The module contains two2N
®
IP Versobus connectors.
These two connectors are fully interchangeable and can be used both as inputs from the
main unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
Used mode: Telecoil (also referred to as t-switch or t-coil)
Maximum power: 2W
Frequency range: 100 Hz – 5 kHz /± 3 dB
External antenna can be connected – Part No.9155043
Short circuit resistance: without limitation