2N IP Verso - Configuration; Function and Use

Installation manual 2N® IP Verso
211 / 241
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3. Function and Use
This section describes the basic and extending functions of thethe2N
®
IP Versoproduct.
Here is what you can find in this section:
3.1 Configuration
3.2 Intercom Control as Viewed by External User
3.3 Touch Display Intercom Control As Viewed by External User
3.4 Intercom Control as Viewed by Internal User
3.5 Maintenance
3.6 Downloads
3.1 Configuration
Configure2N
®
IP Versousing yourPC with anyinternet browser:
Launch your internet browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the usernameAdminand password2n.
You have to know your intercom IP address to log in to the integrated web server. Upon
purchase,2N
®
IP Versois set to the dynamic IP address mode – it retrieves the IP address
automatically if there is a properly configured DHCP server in the LAN. If no DHCP is available,
operate2N
®
IP Versoin the static IP address mode. Refer to the Configuration Manualfor
the2N
®
IP Versoconfiguration details.
If your device remains inaccessible (you have forgotten the IP address, the network
configuration has changed, etc.), you can change the network configuration using the device
buttons.
IP Address Retrieval
Take the following steps to retrieve the2N
®
IP VersoIP address:
Connect(or, if connected, disconnect and reconnect)2N
®
IP Versoto the power supply.
Wait for the second sound signal .
Press the quick dial button on the main unit 5 times.
2N
®
IP Versowill read its IP address.
If the address is 0.0.0.0, it means that the intercom has not obtained the IP address from
the DHCP server.