2N IP Verso - 5-Button

Installation manual 2N® IP Verso
198 / 241
•
•
•
•
•
•
•
•
IN1 IN1 terminals for input in passive/ active mode (−30 V to +30 V
DC)
 OFF = open OR U
IN
> 1.5 V
 ON = closed contact OR U
IN
< 1.5 V
IN2 IN2 terminals for input in passive/active mode(−30 V to +30 V DC)
 OFF = open OR U
IN
> 1.5 V
 ON = closed contact OR U
IN
< 1.5 V
TAMPER Tamper switch (9155038) input
5-Button
The 5-button module (Part No.9155035)is one of the2N
®
IP Versointercom elements and is
used for extending the number of buttons.
The module contains two2N
®
IP Versobus connectors.
These two connectors are fully interchangeable and can be used both as inputs from the
main unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
Nametag dimensions:
1 button: 52,0 (W) x 15.2 (H) mm (dimensional tolerance: +0; −0.5 mm).
5 buttons: 57.5 (W) x 89.0 (H) mm (dimensional tolerance: +0; −0.5 mm).
Refer towww.2n.comfor the nametag printing template.