2N IP Verso - RFID Card Reader; Touch Keypad

Installation manual 2N® IP Verso
187 / 241
•
•
•
•
•
•
•
•
•
•
•
•
•
Keypad
The Keypad (Part No.9155031)is one of the2N
®
IP Versointercom elements and provides a
numerical input in the system.
The module contains two2N
®
IP Versobus connectors.
These two connectors are fully interchangeable and can be used both as inputs from the
main unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
Touch Keypad
The Touch keypad (Part No.9155047)is one of the2N
®
IP Versointercom elements and
provides a numerical input in the system.
The module contains two2N
®
IP Versobus connectors.
These two connectors are fully interchangeable and can be used both as inputs from the
main unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
RFID Card Reader Module 125 kHz
The 125 kHz RFID card reader (Part No.9155032)is one of the2N
®
IP Versointercom elements
and is used for reading RFID card Ids in the 125 kHz band.
The module contains two2N
®
IP Versobus connectors.
These two connectors are fully interchangeable and can be used both as inputs from the
main unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
The following RFID cards can be read:
EM4xxx

•
Caution
To increase the reader's reading distance in combination with a touch display in a
single installation, we recommend you to pull the M-Bus and LAN cables through
separate bushings to avoid their crossing.
