2N IP Verso - Fingerprint Reader

Installation manual 2N® IP Verso
196 / 241
•
•
•
•
•
•
•
•
•
Fingerprint Reader
TheFingerprint reader (Part No.9155045) is one of the 2N
®
IP Verso intercom modules and is
used for automated verification of human fingers for access control and intercom control.
The module contains two2N
®
IP Versobus connectors.
These two connectors are fully interchangeable and can be used both as inputs from the
main unit and outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
Important module properties:
FBI PIV and Mobile ID certification – FAP20
Durable glass touch surface
Rejects spoof fingerprints
−20 to 55 ºC operating temperature range
0–90% relative humidity, noncondensing

•
•
Note
A higher moisture may deteriorate finger papillary line scanning. You are advised
to dry your finger and the reader scanning surface for successful authentication.
Fingerprint scanning can be rather difficult with older persons whose papillary
lines are no so distinct (lower finger elasticity due to age requires a higher pressure
for scanning and the fingerprint might be blurred).
