2N IP Verso - Intercom Control as Viewed by Internal User

Installation manual 2N® IP Verso
219 / 241
Entry
The Entry mode helps you enter the switch codes. Enter the switch digital code and click
for confirmation. You can also enable Scramble keypad in the Keypad
mode via the web interface to scramble the numerical keypad buttons before every new display
in order to prevent third persons from seeing the code to be entered.
3.4 Intercom Control as Viewed by Internal User
Call Answering
You can answer the incoming calls to the2N
®
IP Verso intercom using your phone like any other
calls. You can unlock the door, activate/deactivate a user/profile via your phone keypad during
the call. The calls, however, are time-limited to avoid unintentional blocking of the2N
®
IP
Versoline. Set the maximum call duration in theCall time limit(refer tothe Intercom
Configuration / Services / Phone / Calls subsection of Configuration Manual). Press # on your
phone anytime to extend the call time. The automatic call termination is signalled with a short
beep 10 s before the call end.
Calling to 2N
®
IP Verso
2N
®
IP Versoallows you to answer incoming calls. Set the required parameters in the Incoming
calls group;refer totheIntercom Configuration / Services / Phone / Calls subsection of
Configuration Manual.