2N IP Verso - Extending Module Connection; Keypad

Installation manual 2N® IP Verso
181 / 241
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
2.4 Extending Module Connection
2N
®
IP Versoallows you to connect the following extending modules:
Infopanel
Keypad
Touch Keypad
RFID Card Reader 125 kHz
RFID Card Reader 13.56 MHz, NFC Support
Secured RFID Card Reader 13.56 MHz, NFC Support
Bluetooth & RFID Reader 125kHz, 13.56 MHz, NFC
Bluetooth & RFID Reader 125kHz, secured 13.56 MHz, NFC
Touch Keypad & RFID Reader 125 kHz, 13.56MHz, NFC
Touch Keypad & RFID Reader 125 kHz, secured 13.56 MHz, NFC
Bluetooth Reader
Touch Display
Induction Loop
Fingerprint Reader
I/O Module
5-Button
OSDP Module
Wiegand Module
Tamper Switch
Blind Panel
Security Relay
Module Bus Interconnection
All the2N
®
IP Versomodules, except for the Tamper switch, are interconnected via a bus. The
bus starts on the main unit and goes over all the modules. The order of modules on the bus is
irrelevant. And it also irrelevant which bus connector on the module is used as the input and
which is used as the output.
The modules include a 220 mm long interconnecting cable; the Wiegand (9155037), I/O modules
(9155034) and OSDP modules(91550371)include an 80 mm long interconnecting cable.
It is possible to order separate bus cables of the lengths of 1 m, 3 m, or 5 m (Part
Nos.9155050/9155054/9155055), which are designed for remote2N
®
IP Versomodule
installations. Typically, they are used for an RFID card reader mounted on a wall opposite to
the2N
®
IP Versoinstallation. The cable may be used only once on the bus. In extensive
installations, the total bus cable length may not exceed 7 m.