2N IP Verso - Page 212

Installation manual 2N® IP Verso
212 / 241
•
•
•
•
•
•
•
Network Setting Reset and Dynamic / Static IP Address Switch
To reset the network parameters and switch the dynamic /static IP address of2N
®
IP
Versofollow the instructions below:
Connect (or, if connected, disconnect and reconnect)2N
®
IP Versoto the power supply.
Wait for the first sound signal .
Press the quick dial button on the main unit 15 times.
Network parameter reset and DHCP switch are signaled by the sound.
For devices with FW versions 2.33 and lower, wait until the device is automatically
restarted.
After restart, the static IP address mode is switched into the dynamic IP address and
vice versa.
Simultaneously, all theSystem / Networkparameters are reset to default values. This is
useful where it is impossible to connect to the device due to wrong VPN configuration, for
example.
•
Note
Be sure to press the button sequence within thirty seconds after the sound signal
for security reasons. Up to 2 s intervals are allowed between the presses.
