3Com 4210G Series - Page 1029

23-21
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Enter test type view of a test
group
type { dhcp | dlsw | ftp | http |
icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
—
Configure the descriptive string
for a test group
description text
Optional
By default, no descriptive string
is available for a test group.
Configure the interval between
two consecutive tests for a test
group
frequency interval
Optional
By default, the interval between
two consecutive tests for a test
group is 0 milliseconds, that is,
only one test is performed.
If the last test is not completed
when the interval specified by
the frequency command is
reached, a new test is not
started.
Configure the number of
probes in an NQA test
probe count times
Optional
By default, one probe is
performed in a test.
Only one probe can be made in
one voice test. Therefore, this
command is not available in a
voice test.
Configure the NQA probe
timeout time
probe timeout timeout
Optional
By default, the timeout time is
3000 milliseconds.
This parameter is not available
for a UDP jitter test.
Configure the maximum
number of history records that
can be saved in a test group
history-records number
Optional
50 by default.
Configure the maximum
number of hops a probe packet
traverses in the network
ttl value
Optional
20 by default.
This parameter is not available
for a DHCP test.
Configure the ToS field in an IP
packet header in an NQA
probe packet
tos value
Optional
0 by default.
This parameter is not available
for a DHCP test.
Enable the routing table
bypass function
route-option bypass-route
Optional
Disabled by default.
This parameter is not available
for a DHCP test.