6-7
To do… Use the command… Remarks
Enter VLAN view vlan vlan-id
Required
If the specified VLAN does not exist,
this command creates the VLAN first.
Assign one or a group of
access ports to the current
VLAN
port interface-list
Required
By default, all ports belong to VLAN 1.
In VLAN view, you only assign the access ports to the current VLAN.
2) In interface or port group view
Follow these steps to assign an access port (in interface view) or multiple access ports (in port group
view) to a VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer-2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter
interface
view or port
group view
Enter port
group view
port-group manual
port-group-name
Required
Use either command.
z In Ethernet interface view,
the subsequent
configurations apply to the
current port.
z In port group view, the
subsequent configurations
apply to all ports in the port
group.
z In Layer-2 aggregate
interface view, the
subsequent configurations
apply to the Layer-2
aggregate interface and all
its member ports.
Configure the link type of the
port or ports as access
port link-type access
Optional
The link type of a port is
access by default.
Assign the current access
port(s) to a VLAN
port access vlan vlan-id
Optional
By default, all access ports
belong to VLAN 1.
To Next Page
Loading...
