1-39
Figure 1-9 Configure AAA for SSH users by a RADIUS server
Internet
Switch
SSH user
RADIUS server
10.1.1.1/24
Vlan-int2
192.168.1.70/24
Configuration procedure
1) Configure the RADIUS server. (iMC)
This example assumes that the RADIUS server runs iMC PLAT 3.20-R2602 or iMC UAM 3.60-E6102.
# Add an access device.
Log into the iMC management platform, select the Service tab, and select Access Service > Access
Device from the navigation tree to enter the Access Device page. Then, click Add to enter the Add
Access Device window and perform the following configurations:
z Set both the shared keys for authentication and accounting packets to expert
z Specify the ports for authentication and accounting as 1812 and 1813 respectively
z Select Device Management Service as the service type
z Select 3Com as the access device type
z Select the access device from the device list or manually add the device with the IP address of
10.1.1.2
z Click OK to finish the operation
To Next Page
Loading...
