3M Clean-Trace LM1 - b. Performing an Unplanned Test from a Registered Luminometer

14
EN
(English)
▪ For ATP Test type, tap [Start] to begin measuring. A progress bar appears and moves from left to right. The ATP
results will be displayed after about 7 seconds in the number of RLUs. This result will be stored in the Luminometer
memory so it can be synchronized with the 3M Clean-Trace Hygiene Management Software.
▪ After ATP test completion, remove the Test swab from the 3M Clean-Trace Luminometer; press the rocker cap, grasp
the top of the Test swab, and pull upwards. Follow current industry standards and local regulations for disposal of
used Test swabs.
To perform another unplanned ATP test, tap [Add new] or [Add unplanned test] and repeat this process.
To do a retest, tap [Retest] then tap [Start].
For Unplanned test, “Retest” is only allowed if the result has not been synchronized yet.
Tap to edit
Unplanned Test Name
Tap to Select
Test type
Tap Pass or Fail
For Visual Inspection
Tap Start
for ATP Test