f.
Performing a Visual Inspection Test on a Test Point
If a Test point includes an ATP test and a Visual Inspection Test type, the Visual Inspection Test type appears immediately,
before the ATP Test type. The user may run the tests in sequence, or in any order.
If the Test type is set to Visual Inspection, recording the result will means tap
[Pass]
or
[Fail]
.
Tap home anytime to return home, to the list of assigned Sample plan(s)
g.
Adding a Comment to a Test result
Comment(s) must be pre-set in the
3M™ Clean-Trace™
Hygiene Management Desktop Software and transferred to
the 3M Clean-Trace LM1 Luminometer through synchronization.
Comments are currently allowed for Pass, Caution or Fail results, and must be added before the result is
synchronized. Multiple comments may be selected per test run.
To add a comment to a test result
▪ Tap the icon to add comment. The Comments screen and any previously added
comments appears.
▪ Tap [Comments] drop down, then tap to select comment(s) to add.
▪ Tap [Save] to append selected comment to the Test result.
To Next Page
Loading...
Need help?
General
