3M Clean-Trace LM1 - d. Setting Up Synchronization with a Wi-Fi Connection; e. Setting Wi-Fi Auto Synchronization Time

24
EN
(English)
If the information entered are correct, “ Your connection looks good! ” will display.
If information entered does not allow the Luminometer to communicate with the Clean-Trace Desktop
Software, “ There is a problem with the connection ” will display, with suggestions to resolve.
e. Setting Wi-Fi auto Synchronization Time
The 3M™ Clean-Trace™ LM1 Luminometer will automatically sent
all un-synchronized Test results present in Luminometer to the
Clean-Trace Desktop Software at the set Wi-Fi auto-sync time .
To set Wi-Fi auto-sync time:
▪ Get to the Settings screen .
▪ Tap [Wi-Fi auto-sync time] .
▪ Use the Up and Down navigation keys or tap or
to adjust the Wi-Fi auto Sync time.
▪ Tap [Done] to save or [Cancel] to skip.
If the 3M Clean-Trace LM1 Luminometer is “On” and configured for Wi-Fi synchronization, The 3M Clean-Trace
Luminometer will automatically sent all Test results present on the device to the 3M Clean-Trace Desktop Software
at the Wi-Fi auto-sync time set. The Wi-Fi auto-sync will happen with no user intervention and will not interrupt any
user operation on the device.