3M Clean-Trace LM1 User Manual

23
EN
(English)
d. Setting up Synchronization with a Wi-Fi Connection
If this is the first time using this Luminometer on this 3M™ Clean-Trace™ installation, first follow steps in the 3M
Clean-Trace Hygiene Management Software User Manual to add the Luminometer detail in the desktop software –
this process is also referred to as Luminometer registration. The 3M Clean-Trace Luminometer registration is
automatic when synchronizing over USB connection.
1. Make sure Wi-Fi is enabled on the 3M Clean-Trace LM1 Luminometer and connected to the appropriate wireless
network. Follow steps below to enable Wi-Fi:
▪ Get in the Setting screen, then tap on [Wi-Fi network -] . The user may also get to Wi-Fi Configuration
through the general settings by double tap the top part of
the screen. This will open the “ General Settings ” screen.
The General Settings can also be accessed from the
Settings screen.
▪ In the General settings screen, tap the Wi-Fi icon. In the next screen, tap the [Wi-Fi] icon.
▪ In the Wi-Fi network screen, tap the [On/Off] toggle as needed to turn on the Wi-Fi.
▪ In the list of available Wi-Fi network(s),
connect to the wireless network that
allows communication with the
computer where the 3M Clean-Trace
software is installed. If the Wi-Fi is
secured, enter the Wi-Fi security
credential. Obtain the Wi-Fi credentials
from your IT support, as needed.
2. Set Preferred connection to Wi-Fi
▪ Get to the Settings screen
▪ Tap [ Preferred Connection - (connection type) ].
▪ Tap [Wi-Fi].
▪ Tap [Select ] to confirm and exit.
3. Set Wi-Fi sync configuration
▪ Tap [Wi-Fi sync configuration].
▪ Provide the IP address or the hostname of the computer where the 3M Clean-Trace software is installed. An
On-screen tip is provided but the user may obtain this information from their IT Support. The IP Address is
preferred for this configuration, to minimize potential naming translation issue.
▪ Tap [IP address or hostname] and use the keyboard to enter the IP address of the 3M Clean-Trace host
computer. Obtain this information from your IT support.
▪ Tap [ Test Connection ].
Double tap to open General
settings

3M Clean-Trace LM1 Specifications

General

Brand	3M
Model	Clean-Trace LM1
Category	Measuring Instruments
Language	English