h.
Recording Temperature or pH for a Test point within a Sample plan
If a Test point includes pH, Temperature, or other Test types, the first Test type to be presented for testing is the Visual
Inspection if enabled, then ATP tests, if enabled. The user may run the tests in the default sequence presented or in any
order.
Temperature, pH, or other Test types can be set to be recorded in the form of numeric value, or qualitative Pass/Fail value.
▪
Follow instructions for Performing an ATP Test on a Test Point within a Sample plan to locate the Test point. Unplanned
tests do not allow recording data for Temperature, pH, or other Test types.
▪
Use directional buttons or the touchscreen to navigate to the next
Test type or Test point as needed.
▪
When the right Test point is on the screen with Test type being
Temperature or pH:
o
If the Test type is qualitative or Pass/Fail, tap the appropriate
Test result,
[Pass]
or
[Fail]
.
Tap
[Retest]
to re-record a new Test result or use directional
buttons or touchscreen to navigate to the next Test type or
Test point.
o
If the Test type is quantitative or numeric, tap on the open
field then use the number pad to enter the Test result and
tap the green enter , up to two decimals are allowed.
Tap
[Retest]
to re-record a new Test result or use
directional buttons or touchscreen to navigate to the next
Test type or Test point.
i.
Moving to another Test point in the same Sample plan
▪
To move to the next Test point in a Sample plan, tap
[>]
. The name of the next
Test point in the Sample plan displays.
▪
To move to a previous Test Point in a Sample plan, tap
[<]
. The name of the
previous Test point in the Sample plan displays.
▪
In the List view scroll up or down to view Test points in a Sample plan.
Tap
[ ]
to expand Test point and view associated Test types.
To Next Page
Loading...
Need help?
General
